Packed up some Sunfish bits to ship out.
A couple of notes about the deck edge trim. Be careful when removing the corner trim, it is easy to bend the trim and tear the thin piece of aluminum around the rivet hole.
The trim is attached with a rivet that is only supposed to go through the top of the trim, not all the way through. Keep an eye out for sharp burrs on the bottom side of the trim, usually from where drill bits went too far when the trim was removed or when new holes were drilled in the deck edge flange. Knock the edges down with a file, they can catch unsuspecting fingers.
Here are the specs for the coaming rivets.
Send us a message if you need parts!
No comments:
Post a Comment