Tuesday, November 20, 2018

Alcort Super Sailfish ZSA ZSA 20 Nov 18 Bottom Ply Fitting

20 Nov 18:

Used a cargo strap to pull the panels tight for fitting. Ran a pencil down the side of the keel strip to get a scribe line, pulled the panel off and planed the high spots down with a Stanley #5 Jack plane.


Did both sides, all 4 panels.



Plywood panel edges are hard to plane, with the ply grain running different directions. My plane iron needed sharpening so I finally pulled out the Work Sharp 3000 power sharpener and tried it out. I have never been a pro at hand sharpening, usually end up butchering a blade, the WS3000 worked great and I had a nice sharp blade to do the plywood edge.


It even cleaned up my cheapo demolition chisel!



Log of ZSA ZSA.

No comments:

Post a Comment